Cognex表面檢測系統在硅鋼酸軋線中的改造應用
張國忠，林育茲，劉永春
（廈門大學嘉庚學院 機電工程系，福建 廈門 361000）
摘 要：介紹了Cognex 表面檢測系統的基本原理、構成和在硅鋼酸軋線中的應用情況。對其在運行過程中出現的四類問題加以分析說明，并從中找到合適的解決方案對其進行了改造。結果表明：該改造方案能夠使檢測光源亮度波形明顯好轉，降低了設備維護難度及減少了機組停機時間，保證了鋼帶產品的生產質量。
關鍵詞：表面缺陷；缺陷檢測；光源；攝像機；編碼器
中圖分類號：TM701.3 文獻標識碼：B 文章編號：1007-3175(2016)07-0038-03
Transform and Application of Cognex Surface Detection
System for PL-TCM of Silicon Factor
ZHANG Guo-zhong, LIN Yu-zi, LIU Yong-chun
（Department of Mechanical and Electrical Engineering, Xiamen University Tan Kee College, Xiameng 361000, China）
Abstract: Introduction was made to the fundamental principle, composition of Cognex surface detection system for the PL-TCM of Silicon, this paper analyzed various problems and failures arising in the operational process and found out the right solution to tackle the problems of their transformation. The results show that the modification scheme could make the detection light source luminance waveform come a long way and reduce the difficulty of equipment maintenance and the time of unit machine halt, which guarantees the production quality of steel belt.
Key words: surface defect; defect detection; light source; vidicon; encoder
參考文獻
[1] 劉小軍， 李斌， 顧曉琳， 等. Cognex表面檢測儀在八鋼1 750 mm熱軋的應用[J]. 新疆鋼鐵，2010(3)：11-13.
[2] 張洪濤，段發階，丁克勤，等. 帶鋼表面缺陷視覺檢測系統關鍵技術研究[J]. 計量學報，2007，28(3)：216-219.
